Your water heater is one of the most used and more expensive appliances in your home, and consumes a large portion of your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving with regards to your home heating and costs.
Regular flushing of one’s water heater is among the single most important step you can take to prolong its service life in addition, it save energy. For time, sediments mount up in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not only destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regions of the country, the common water heater lasts 3-5 years. Regularly flushing your hot water heater can double the life of your hot water heater from 3-5 to 7-10 years. Something else costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is vital in today’s economic condition. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.
To drain your water heater, which will help should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to the water heater. Next, close the water supply valve located on the water inlet line going into your water heater. You may then connect a garden hose to the drain valve located at the base of the heater. Open the drain and allow it working out until all of your water has emptied from the hot water heater. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until drinking water flows out gradually. This will allow air to vent via the heater and the water lines. Finally, you can turn the thermostat back to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your property to filter or condition the water so may less corrosive to your plumbing system, particularly in areas possess hard water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in place to discuss options and merchandise to fit the bill.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX